Can-Am Spyder Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter · #1 ·
H E L P ! !
I went to do a simple upgrade to my 2021 RTL... I was going to put on the "Flasher Kit" from Slingmods, so my brake lights would flash 3 times before going solid red whenever I pressed on the brake petal!!
I watched the Slingmods video on exactly how to do this 3 times... got my tools and the new Flasher Kit ready... and started just as the video says!!
STEP 1. Remove the 4 screws, which are actually push pins, by screwing the head just enough to pull the push pin out!!
Well, it seemed simple enough... except those "push pins" with a Phillips screw head don't unscrew... when you try, you just strip out the head of the push pin!!! Has anyone had any luck taking off the side covers to get to the wiring... and how did you do it!!!
My photos... the pushpin is a screen grab from Slingmods!!
For reference... https://youtu.be/T--dPhShCAg. .
Product Hood Motor vehicle Automotive exterior Automotive lighting
Hand Tire Tool Vision care Finger

Grey Automotive exterior Automotive tire Motor vehicle Gas
 

·
Registered
Joined
·
5 Posts
I had the same problem They dont screw out They are not a helical thread but just one thread that goes around the pin in a circle. I just got a pair of needle nose and pulled them out and then ordered new push pins to put back in.
 
1 - 4 of 4 Posts
Top