Can-Am Spyder Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 · (Edited)
New Spyder RT-S in garage

Well the spyder is in garage and now has 250 miles on it. Being a Harely rider for years, I must say this is very different. So far I think the spyder is great, still learning the curves! My question is > Did your tool kit come with the tool to take your side panels off? Mine has a small star like tool but it doesn't fit the side panels. The screws seem to have a small pin in the center, doesn't anyone know the size or correct tool for these?
Would like to thank everyone on this forum for there info on the RT ! Really helped me in my purchase!
Thanks zztop169:)
 

·
Registered
Joined
·
22 Posts
Hey neighbor.....where are you located in TN? I am in Powell, which is just outside knoxville. We also have the 2010 RT-S and just got it back from the 600 mile service. I have poked around in the tool kit, but only used the tool needed to adjust the pass. floor boards. The tool you describe, sound like the "tamper proof" hex head. We are still getting used to the handling. Sold our BMW K1200LT which had us spoiled, I think. This is WAY different.
 

·
Registered
Joined
·
1 Posts
No tool needed

Hey friend no need to remove those screws. They just hold on fastners that go into grommets that hold side panel in place. Just give a pull and panel will release.

Have fun will new RT

jingles
 
1 - 4 of 4 Posts
Top