Can-Am Spyder Forums banner

floor boards

3686 Views 2 Replies 3 Participants Last post by  powerbyaj
I Have found the pegs are to high to the seat. I Have a bad right leg (post stroke) and want to move the pegs down 1 1/2 inchs.

HAS any one seen a lower peg system?? I am not able to manufacture myself.

Also I heard about the 2009 1/2 modle that has lower pegs. Any idea if it's true?

IF you hear anything let me know,

thank you

[email protected]
1 - 3 of 3 Posts
Floorboards, self made and lower!

Hello, floto612 here......

I fabbed my own floor boards and installed them using the original BRP pins and clips. Simple checkerplate aluminum with a spacer block and support rod.
This lowered my boards about 1" and allowed for a very, very nice forward angle of about 30'.
Being a paraplegic, with no feeling or control of my legs, I decide to build a 'partial fence' around the boards. I have photos of this mod and can send seperate, as they are too large for this site. They will with stand a 300 pound person standing on a single peg.......so, should be good enough for your use. Send me a private email, with your email address and I can get the photos over to you.
I Have found the pegs are to high to the seat. I Have a bad right leg (post stroke) and want to move the pegs down 1 1/2 inchs.

HAS any one seen a lower peg system?? I am not able to manufacture myself.

Also I heard about the 2009 1/2 modle that has lower pegs. Any idea if it's true?

IF you hear anything let me know,

thank you

[email protected]
I saw lower passenger pegs at a demo ride in riverside last week. Heading to a demo again this weekend will take pictures. I will ask about rider lower pegs.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top