2016 Can Am Spyder RT Limited with 34,500 miles. Had an issue where I had a lot of non-sense codes thrown including "Limp Home". This was all due to the battery having 1 bad cell. Had to have the bike put on a roll back and delivered to the house.
I decided to purchase the BUDS/BUDS2 program and hardware. Cleared the codes, installed a new YUHASA battery. Now the engine will run, but only for 30 seconds then dies. Installed a new fuel filter but no change to the engine run time. No codes are shown.
I know that there are only 3 basic things needed for an engine to run: fuel, air and spark. It seems like a fuel problem because it only runs for about 30 seconds then sputters to a stop.
2 questions. I cleared the codes before I replaced the battery, could this be a problem? Could the fuel pump be bad? I have replaced the air filter about 150 miles ago, also did an oil change with BRP kit. Any time I am not riding the bike it lives on a Battery Tender in my garage.
Any help or advice is greatly appreciated.
Harold
SW Missouri
PS: This is an SE6 1330 Rotax engine
sp
I decided to purchase the BUDS/BUDS2 program and hardware. Cleared the codes, installed a new YUHASA battery. Now the engine will run, but only for 30 seconds then dies. Installed a new fuel filter but no change to the engine run time. No codes are shown.
I know that there are only 3 basic things needed for an engine to run: fuel, air and spark. It seems like a fuel problem because it only runs for about 30 seconds then sputters to a stop.
2 questions. I cleared the codes before I replaced the battery, could this be a problem? Could the fuel pump be bad? I have replaced the air filter about 150 miles ago, also did an oil change with BRP kit. Any time I am not riding the bike it lives on a Battery Tender in my garage.
Any help or advice is greatly appreciated.
Harold
SW Missouri
PS: This is an SE6 1330 Rotax engine
sp