Can-Am Spyder Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hi all,

I'm installing an electronic cruise control that is a Rostra unit ( replacement for Audiovox unit ) on a 09 SE5. I attempted to use the supplied loop cable to piggy back it to the throttle cable but the the throttle cable barrel slides into a recess and it will not allow the loop cable to fit.

I've seen a few pics posted on here showing one installation where the pulley was drilled and riveted. Another pic showed the servo cable attached to a lever beyond the throttle cable pulley but my throttle body does not resemble that picture.

So if anyone has some guidance and/or pictures that you can offer, it would be much appreciated.

You can reply here or PM me.

Thanks in advance,

Ray
 
1 - 1 of 1 Posts
Top