Can-Am Spyder Forums banner
1 - 2 of 2 Posts

· Registered
15 Posts
Discussion Starter · #1 ·
I finally got around to replacing the stock H4 bulbs with BEAMTECH fanless LED bulbs. I have run these in all my vehicles and bikes that did not come with factory LEDs. Install was simple but I did need to cut the rubber seal a bit. See photo with red line as to were I cut the seal. This still allowed a OK seal around the light and able to slip over the plug and cooling fins. The fins do have some heat but should not be enough to melt the rubber or at least is has not in the past on other installs.
Total cost was 1 hour of time and $40.00 for the lights
Motor vehicle Automotive lighting Automotive tire Hood Automotive exterior
Motor vehicle Automotive design Fender Automotive lighting Gas
Automotive tail & brake light Vehicle Motor vehicle Hood Car
Tire Automotive tail & brake light Wheel Light Automotive lighting
Automotive lighting Automotive tire Wheel Tire Vehicle
Automotive tire Camera lens Reflex camera Camera accessory Cameras & optics
Motor vehicle Automotive tire Automotive design Rim Gas
Audio equipment Gas Auto part Automotive tire Camera accessory
Light Cosmetics Gas Tints and shades Liquid
1 - 2 of 2 Posts