Spyder RT Factory CB Antenna Fix/Upgrade - Can-Am Spyder Forums: The Y-factor Community

JMJOHN · #1 (**permalink**) 12-10-2011, 07:40 AM

Many of the factory installed Spyder RT CB antennas improperly insulate the antenna staff from the brass mounting block, causing high SWR and/or poor CB transmission capability from the CB radio,,,,,

J&M has just released a CB antenna upgrade kit for the Can-Am Spyder RT, that addresses these issues,,,,,

Included in this kit is a replacement brass mounting block that has been machined to fit in the exact same spot as the factory antenna block, but with the correct sized and threaded mounting hole, to allow the industry standard CB antenna staffs to fit, and to properly conduct RF transmissions from the CB antenna coax, all the way thru to the antenna staff itself,,,,,

This new kit includes a pre-tuned, (no SWR tuning necessary) 3’, top-loaded CB antenna staff, replacement CB antenna brass mounting block and complete installation instructions. ((see J&M Products for the CanAm Spyder RT ,,,

J&M’s Vice-President, Melinda Carevich rides a beautiful new blue RT, with the complete audio system and the CB radio portion of the system finally performs on par with J&M’s JMCB-2003 and the CB radio on our 2012 Gold Wing ,,,,,

mishapman · #2 (**permalink**) 12-10-2011, 08:52 AM

Advertising is not allowed on this site unless you are a paid sponsor. If you wish to continue to advertise your product, please consider sponsoring.

Also please remove links from your signature pointing to your website.

Further advertising without sponsorship will result in removal of account.

Thanks.

John

JMJOHN · #3 (**permalink**) 12-10-2011, 08:15 PM

mishapman ,,,,,,

I understand ,,,, what is the easiest way for J&M to become a sponsor immediately, without trying to use PayPal ? ,,,,

what are your current banner specs ? ,,,,,,

mishapman · #4 (**permalink**) 12-11-2011, 08:03 AM

The prospective advertiser link is:
Can-Am Spyder Forums: The Y-factor Community - Advertise

Sounds like you have a great product. Just need to make sure selling it is done in compliance with board rules. Thanks so much for your interest.

Paladin · #5 (**permalink**) 12-11-2011, 01:04 PM

nice to see someone actually interested in posting a company using the forums rules for a change instead of of just wasting peoples times..

I am interested in the RT products on the website but need to get my main comp back before I can do any e-mailing for info

JMJOHN · #6 (**permalink**) 02-13-2012, 04:03 PM

don't forget to look at the NEW J&M PASSENGER headset LOWER cord, for the RT system, that includes the PTT switch and volume up/dn buttons made specifically for the Spyder RT audio/CB/Intercom system ,,,, see HC-ZVT-X Product Information ,,,